Wedding Couple 3D Mould

Wedding Couple 3D Mould

Do you need to spice up your wedding favours? or congratulate the happy couple? This 3D couple of a bride and groom is a perfect way to add a unique flare to a wedding! The mould is constructed via cutting down the lines between the two halves and being pressed together. The base is then cut for a pouring hole.  Secure with extra bulldog clips around the edges and placed in a bowl for support. Pour your soap into the hole and allow to set fully before unmoulding. Unmoulding may be more successful after being place in refrigerator for a short amount of time and then try again. Once unmoulded you can use some soap paint on the surface to add some colour to the grooms tux or brides hair.

Clean up seam marks with the back of a butter knife and it will be ready to go!

These moulds are a thinner plastic than some and do not tolerate temperatures over 60ÂșC well so advise you soap cooler with this one.

Capacity:  96gm
Length:  55mm
Width:  60mm
Height:  95 mm


2 cavities (4 halves)

Write a review

Please login or register to review
  • Product Code: MOWC
  • Availability: In Stock
  • $4.50
  • Ex Tax: $4.09