699803

Bear 3D Mould

Bear 3D Mould

Not too small, not too big, this 3D bear mould is just right!
The assembly of this bear mould requires cutting down the lines between the two halves  which can then be  pressed together and a filling hole created in the base.  Secure with extra bulldog clips around the edges and placed in a bowl for support and it is able to be filled.  Allow to set before carefully unmoulding.  If the bear is not unmoulding successfully, place in refrigerator for a short amount of time and then try again.
Clean up seam marks with the back of a butter knife and it will be ready to go.

These moulds are a thinner plastic than some and do not tolerate temperatures over 60ÂșC well so advise you soap cooler with this one.


Capacity:  60gm
Length:  40mm
Width:  35mm
Height:  90mm


2 cavities (4 halves)



Write a review

Please login or register to review
  • Product Code: MOBEAR
  • Availability: In Stock
  • $4.50
  • Ex Tax: $4.09
This pin allows the wick to be centered on each and every pour.  Place the wick pin in the bott..
$2.95
Ex Tax: $2.68
This kitty cat is an adorable unique soap to bring in some fun. You can colour it the same as your f..
$4.50
Ex Tax: $4.09
There is no ugly duckling present in this beautiful swan mould! This 3D mould is constructed via cut..
$4.50
Ex Tax: $4.09