Scottie Dog 3D Mould

Scottie Dog 3D Mould

The Scottie Dog 3D Soap Mould makes a really intriguing 3 dimensional soap which weighs 90gm.  The dog measures 9cm tall with a base of 7cm,or 8cm to the tail.  He has a width of 4cm, The mould has a front and back section allowing a complete unit. This mould does require a little dismemberment and reconfiguration to make into the 3D formatting.  To construct this mould ready for use cut the mould  into two sections.  Align the nobbles on the mould  and join with bulldog clips or the like.  Cut a hole in the base to allow the mould to be filled.  Place in a container of an appropriate size (cup or bowl are good) to ensure the dog stays upside down.  Fill as required and allow to set before carefully unmoulding and trimming of excess soap where the seams joined.  Present as desired.

These moulds are a thinner plastic than some and do not tolerate temperatures over 60ÂșC well so advise you soap cooler with this one.

Capacity:  90gm
Length:  70mm
Width: 40mm
Height:  90mm

1 cavities (2 halves)

Write a review

Please login or register to review
  • Product Code: MOSD
  • Availability: In Stock
  • $4.50
  • Ex Tax: $4.09
Unscented Bath CrystalsThese completey unscented bath crystals are a base ready for you to add your ..
Ex Tax: $4.55
Use a heat gun or hot hair dryer to shrink these sleeves snuggly around your soaps to protect them w..
Ex Tax: $0.18
This flower silicon embed mould is an easy and beautiful way to add something unique to your soap cr..
Ex Tax: $22.73
Extremely easy colouring method suitable for cold process soap, hot process soap an..
Ex Tax: $20.18