Swan 3D Mould

Swan 3D Mould

There is no ugly duckling present in this beautiful swan mould! This 3D mould is constructed via cutting down the lines between the two halves and being pressed together. Cut a filling hole in the base.  Secure with extra bulldog clips around the edges and placed in a bowl for support. Allow your swan to set into shape before unmoulding. Unmoulding may be more successful after being place in refrigerator for a short amount of time and then try again. The wings are created by simply pouring the soap into the mould and allowing it to set before assembling. To wing your swan you use a small dab of melted soap and hold wings in place until solid.

Clean up seam marks with the back of a butter knife and it will be ready to add some elegant beauty to your lake (or soap).


These moulds are a thinner plastic than some and do not tolerate temperatures over 60ÂșC well so advise you soap cooler with this one.


Capacity:  132gm
Length:  75mm
Width:  65mm
Height:  80mm


2 cavities (4 halves)


Write a review

Please login or register to review
  • Product Code: MOSW
  • Availability: In Stock
  • $4.50
  • Ex Tax: $4.09
This pin allows the wick to be centered on each and every pour.  Place the wick pin in the bott..
$2.95
Ex Tax: $2.68
This kitty cat is an adorable unique soap to bring in some fun. You can colour it the same as your f..
$4.50
Ex Tax: $4.09
Not too small, not too big, this 3D bear mould is just right! The assembly of this bear mould requir..
$4.50
Ex Tax: $4.09
Due to incorrect shipping choices being made this product will now have shipping calculations done m..
$6.00
Ex Tax: $5.45