Sheep 3D Mould
Click Image for Gallery
This sweet sheep is an adorable addition on your bathroom bench. You can stay true to its classic white fluffiness or colour it crazy to add some spark!
To construct your sheep the mould is assembled by cutting down the lines between the two halves and then pressed together. A hole big enough for pouring should then be cut into the base of the sheep. Secure with extra bulldog clips around the edges and placed in a bowl for support and it is able to be filled. Allow to set before carefully unmoulding. If the soap is not unmoulding successfully, place in refrigerator for a short amount of time and then try again.
Clean up seam marks with the back of a butter knife and it will be ready to go.
These moulds are a thinner plastic than some and do not tolerate temperatures over 60ºC well so advise you soap cooler with this one.
2 cavities (4 halves)